Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM33C0E _52 Drivetrain _065436 AXLE AND DIFFERENTIAL _0334219 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When removing or installing the front disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 43212 1.INSTALL STEERING KNUCKLE

a.

Secure the steering knuckle between aluminum plates in a vise.

NOTICE:

Do not overtighten the vise.



b.

Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 4 bolts.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)

NOTICE:
·

Be careful not to damage the speed sensor rotor or contact surfaces.

·

Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.




Hide 43340A 2.INSTALL FRONT LOWER BALL JOINT ASSEMBLY

Hide 3.INSTALL FRONT AXLE ASSEMBLY