Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TELEVISION CAMERA (for Rear) › 2017.09–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0334381 TELEVISION CAMERA A

PARK ASSIST / MONITORING  TELEVISION CAMERA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Rear television camera assembly (w/ Parking assist monitor system)
·

Parking assist monitor system initialization

·

Rear television camera assembly optical axis (Back camera position setting)


Parking assist monitor system (Click here)

PROCEDURE

Hide 76801A 1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Hide 2.REMOVE REAR TELEVISION CAMERA ASSEMBLY WITH WIRE

a.
E365382

Disconnect the connector.


b.

Disengage the clamp.


c.
E365383C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws to remove the rear television camera assembly with wire as shown in the illustration.


Hide 86799 3.REMOVE TELEVISION CAMERA WIRE

a.
E365385

Disconnect the connector to remove the television camera wire.


Hide 86790D 4.REMOVE REAR TELEVISION CAMERA ASSEMBLY