DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ACC SW | Power switch | OFF or ON | OFF: Power switch off
ON: Power switch on (ACC) |
- |
| IG SW | Power switch | OFF or ON | OFF: Power switch off or on (ACC)
ON: Power switch on (IG) |
- |
| RR Door Courtesy SW | Rear door courtesy light switch assembly (for RH) | OFF or ON | OFF: Rear door RH closed
ON: Rear door RH open |
- |
| RL Door Courtesy SW | Rear door courtesy light switch assembly (for LH) | OFF or ON | OFF: Rear door LH closed
ON: Rear door LH open |
- |
| FR Door Lock Pos | Front door RH unlock detection switch | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FR Door Courtesy SW | Front door courtesy light switch assembly (for RH) | OFF or ON | OFF: Front door RH closed
ON: Front door RH open |
- |
| FL Door Lock Pos | Front door LH unlock detection switch | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| FL Door Courtesy SW | Front door courtesy light switch assembly (for LH) | OFF or ON | OFF: Front door LH closed
ON: Front door LH open |
- |
| Hood Courtesy SW | Engine hood courtesy switch | OFF or ON | OFF: Engine hood closed
ON: Engine hood open |
- |
| RR-Door Lock Pos SW | Rear door RH unlock detection switch | OFF or ON | OFF: Rear door RH locked
ON: Rear door RH unlocked |
- |
| RL-Door Lock Pos SW | Rear door LH unlock detection switch | OFF or ON | OFF: Rear door LH locked
ON: Rear door LH unlocked |
- |
| Luggage Courtesy SW | Luggage compartment door courtesy light switch signal | OFF or ON | OFF: Luggage compartment door closed
ON: Luggage compartment door open |
- |
| Intrusion Sens OFF SW | Intrusion sensor cancel switch*1 | OFF or ON | OFF: Intrusion sensor cancel switch off
ON: Intrusion sensor cancel switch on |
Not applicable |
| Glass Break Sensor Detection | Glass breakage sensor breakage detection*1 | OFF or ON | OFF: Glass breakage sensor breakage not detected
ON: Glass breakage sensor breakage detected |
Not applicable |
| Intrusion Sensor | Detection status of the intrusion sensor (theft warning ultrasonic sensor)*1 | OFF or ON | OFF: Intrusion not detected
ON: Intrusion detected |
Not applicable |
| Intrusion Sen Conn | Intrusion sensor (theft warning ultrasonic sensor) connection*1 | OFF or ON | OFF: Intrusion sensor not connected
ON: Intrusion sensor connected |
Not applicable |
| Intrusion Sensor Sound Detect | Sound detection status of the intrusion sensor (theft warning ultrasonic sensor)*1 | OFF or ON | OFF: Sound not detected
ON: Sound detected |
Not applicable |
| Panic Function | Setting of customize setting "Panic Function"*2 | OFF or ON | Customize setting displayed | - |
| Intrusion Win Opened | Setting of customize setting "Intrusion Win Opened"*1 | OFF or ON | Customize setting displayed | Not applicable |
*1: Although the item is displayed on the GTS, it is not applicable to this vehicle.
*2: w/ Panic Switch
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body or Entry&Start / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Horn2 | Theft warning siren assembly* | OFF/ON | Not applicable |
| Vehicle Horn | Vehicle horns | OFF/ON | - |
| Security Horn | Security horn assembly | OFF/ON | - |
| Power For Intrusion Sensor | Intrusion sensor (theft warning ultrasonic sensor) power supply* | OFF/ON | Not applicable |
*: Although the item is displayed on the GTS, it is not applicable to this vehicle.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Immobiliser Indicator | Security indicator | OFF/ON | - |