This DTC indicates an internal malfunction of the millimeter wave radar sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A10 | Front Radar Sensor | w/o Full-speed Range Following Function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the millimeter wave radar sensor assembly detects an internal malfunction for approximately 0.3 seconds or more. w/ Full-speed Range Following Function: ·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the millimeter wave radar sensor assembly detects an internal malfunction for approximately 0.3 seconds or more. |
Millimeter wave radar sensor assembly |
When replacing the millimeter wave radar sensor assembly, make sure to replace it with a new one. If a device which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle, and as a result, a DTC may be stored.
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
Replace the millimeter wave radar sensor assembly with a new one.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>REMOVAL
Perform millimeter wave radar sensor assembly adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT