Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2017.12–2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0328967 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P057113  Brake Switch "A" Circuit Open  


DESCRIPTION

When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (brake booster with master cylinder assembly) operates the stop light switch assembly (stop light control relay) to illuminate the stop lights.

If the hybrid vehicle control ECU assembly receives a stop light control relay malfunction signal from the skid control ECU (brake booster with master cylinder assembly), DTC P057113 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
P057113 Brake Switch "A" Circuit Open w/o Full-speed Range Following Function:
·

While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU assembly detects the stop light control relay malfunction signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 0.5 seconds or more.


w/ Full-speed Range Following Function:
·

While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU assembly detects the stop light control relay malfunction signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 0.5 seconds or more.


Pre-collision system

CAUTION / NOTICE / HINT

HINT:

When DTC P057113 is stored by the dynamic radar cruise control system, DTC C1A4B is stored by the pre-collision system. Therefore, if DTC P057113 is stored, inspect the pre-collision system first.


PROCEDURE

1.GO TO PRE-COLLISION SYSTEM

NEXT

END