The hybrid vehicle control ECU assembly communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010487 | Lost Communication with Cruise Control Module Missing Message | When the power switch is on (IG) and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and hybrid vehicle control ECU assembly is detected for 1 second or more. | ·
CAN communication system ·
Hybrid vehicle control ECU assembly ·
Millimeter wave radar sensor assembly |
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | When the power switch is on (IG) and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake booster with master cylinder assembly) and hybrid vehicle control ECU assembly is detected for approximately 2.6 seconds or more. | ·
CAN communication system ·
Hybrid vehicle control ECU assembly ·
Skid control ECU (brake booster with master cylinder assembly) |
| U029387 | Lost Communication With Hybrid Powertrain Control Module Missing Message | w/o Full-speed Range Following Function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU assembly continuously receives a communication cut-off signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. w/ Full-speed Range Following Function: ·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU assembly continuously receives a communication cut-off signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. |
·
CAN communication system ·
Hybrid vehicle control ECU assembly ·
Skid control ECU (brake booster with master cylinder assembly) |
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the power switch on (IG).
Turn the dynamic radar cruise control system on using the cruise control main switch.
w/o Full-speed Range Following Function: Drive the vehicle at 36 km/h (22 mph) or more for 5 seconds or more.
w/ Full-speed Range Following Function: Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U010487, U012287 and U029387 are not output | A |
| DTC U010487, U012287 or U029387 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING