Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light) › 2017.12–2018.04
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0341614 HEADLIGHT ASSEMBLY(for Bulb Type Turn Signal Light) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Bulb Type Turn Signal Light)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Headlight ECU sub-assembly LH
·

Synchronize the vehicle information

·

Perform headlight ECU sub-assembly LH initialization


Lighting system (EXT) (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 2.REMOVE HEADLIGHT ASSEMBLY

a.
E375104C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the headlight assembly as shown in the illustration.


b.
E375105C01
3.01,1.438 3.323,1.635 0.313,0.198 10 true *a 0.552,0.781 0.865,0.979 0.313,0.198 10 true *b 1.5,0.406 1.813,0.604 0.313,0.198 10 true *b 2.594,0.094 2.906,0.292 0.313,0.198 10 true *b
*a Bolt
*b Screw


Remove the bolt and 3 screws.


c.
E375106C01
0,0 0,0 false
V113147

Separate in this Direction


Disengage the guide to separate the headlight assembly as shown in the illustration.


d.
E375107C01
0.333,2.958 0.542,2.76 true 2.094,2.927 2.302,2.729 true 1.958,2.938 2.271,3.135 0.313,0.198 10 true *a 0.208,2.958 0.521,3.156 0.313,0.198 10 true *a
*a Connector Lock Lever
V113147

Disengage in this Direction


Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector to remove the headlight assembly.