Home › General › MAINTENANCE › REAR TURN SIGNAL LIGHT BULB › from 2017.12
RM33C0E _V1 General _065432 MAINTENANCE _0341623 REAR TURN SIGNAL LIGHT BULB A

MAINTENANCE  REAR TURN SIGNAL LIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81498 1.REMOVE REAR COMBINATION LIGHT COVER

Hide 81560 2.SEPARATE REAR COMBINATION LIGHT ASSEMBLY

a.
E364993C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear combination light assembly as shown in the illustration.


b.
E364994

Remove the 2 screws.


c.
E364995C01
2.167,1.417 2.75,0.792 2.75,0.792 1.417,1.458 true 0.385,0.948 0.885,0.948 true 0.49,1.385 1.146,1.083 true 0.302,1.313 0.615,1.469 0.313,0.156 10 false *a 2.792,0.677 3.104,0.833 0.313,0.156 10 false *b 0.188,0.875 0.5,1.031 0.313,0.156 10 false *b
*a Pin
*b Guide
V113147

Separate in this Direction


Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.

NOTICE:

To prevent the rear combination light assembly from falling when disengaging the pin and guides, lightly hold the rear combination light assembly.



Hide 81550L 3.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E387732C01
0,0 0,0 false
V113147

Disconnect in this Direction


Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire.