Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2017.12–2021.02
RM33C0E _58 Vehicle Interior _065458 METER / GAUGE / DISPLAY _0330016 METER / GAUGE SYSTEM U

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  TERMINALS OF ECU  


COMBINATION METER ASSEMBLY


E342209N07
2.208,0.208 2.656,0.427 0.448,0.219 5.146,0.208 5.594,0.427 0.448,0.219 2.313,0.229 2.625,0.427 0.313,0.198 10 false K21 5.25,0.229 5.563,0.427 0.313,0.198 10 false K20

a.

Measure the voltage and resistance and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Signal Input/Output Condition Specified Condition
K21-1 (ILL-) - Body ground LA-L - Body ground Output Headlight dimmer switch off → Headlight dimmer switch in tail or head position Below 1 V → Pulse generation
K21-2 (EP) - Body ground W-B - Body ground - Always Below 1 Ω
K21-4 (INT)*4 - Body ground L - Body ground Output
·

Power switch on (IG)

·

Steering pad switch assembly operated, "TPWS" selected on the multi-information display and "OK" switch (steering pad switch assembly) pressed and held → "OK" switch (steering pad switch assembly) off


Below 1.5 V → 8 to 15 V
K21-5 (SI) - Body ground W - Body ground Input Power switch on (IG), wheel being rotated Pulse generation (See waveform 1)
K21-6 (+S) - Body ground L - Body ground Output Power switch on (IG), wheel being rotated Pulse generation (See waveform 1)
K21-10 (PBKL)*5, *10 - Body ground
·

B - Body ground*8

·

G - Body ground*9


Input Power switch on (IG), front passenger seat belt unfastened → Fastened Below 1 V → 11 to 14 V
K21-11 (PODS)*5, *10 - Body ground L - Body ground Input Power switch on (IG), front passenger seat not occupied → occupied 11 to 14 V → Below 1 V
K21-14 (FR) - K21-33 (FE) LG - BE Input Power switch on (IG), fuel level full → Fuel level low (fuel level warning light on) Pulse generation (See waveform 4)
K21-15 (FV) - Body ground GR - Body ground Input Power switch on (IG) Pulse generation (See waveform 5)
K21-17 (WLVL)*6 - Body ground LG - Body ground Input Power switch on (IG), washer fluid level not low → Washer fluid level low 11 to 14 V → Below 1 V
K21-18 (RLMT)*2 -Body ground BE - Body ground Output Power switch on (IG), rear seat belt warning light LH off → Rear seat belt warning light LH on 11 to 14 V → Below 1 V
K21-19 (RCMT)*2 -Body ground R - Body ground Output Power switch on (IG), rear seat belt warning light center off → Rear seat belt warning light center on 11 to 14 V → Below 1 V
K21-20 (RRMT)*2 -Body ground G - Body ground Output Power switch on (IG), rear seat belt warning light RH off → Rear seat belt warning light RH on 11 to 14 V → Below 1 V
K21-21 (ES) - Body ground W-B - Body ground - Always Below 1 Ω
K21-22 (ECU)*3 - Body ground BE - Body ground Output
·

Power switch on (IG)

·

"OPEN" or "CLOSE" selected on "Rear Sunshade" screen of multi-information display and "OK" switch (steering pad switch assembly) pressed → "OK" switch (steering pad switch assembly) not pressed


Below 1 V → 5.5 V or higher
K21-24 (RLSB)*2 - Body ground SB - Body ground Input Power switch on (IG), rear seat belt LH unfastened → Fastened Below 1 V → 11 to 14 V
K21-25 (RCSB)*2 - Body ground B - Body ground Input Power switch on (IG), rear seat belt center unfastened → Fastened Below 1 V → 11 to 14 V
K21-26 (RRSB)*2 - Body ground LG - Body ground Input Power switch on (IG), rear seat belt RH unfastened → Fastened Below 1 V → 11 to 14 V
K21-27 (OILW) - Body ground W - Body ground Input Power switch on (IG), engine oil level not low → Engine oil level low Below 1 V → 11 to 14 V
K21-28 (MSM+) - Body ground GR - Body ground Input Power switch on (IG), up, down, right and left switches on steering pad switch assembly not pushed 4.8 to 5.2 V
K21-29 (MSTI) - Body ground R - Body ground Input Power switch on (IG), OK and back switches on steering pad switch assembly not pushed 4.8 to 5.2 V
K21-31 (CANL) W Input/Output - -
K21-32 (CANH) B Input/Output - -
K21-34 (LST1) - Body ground*1 L - Body ground Input "Ready to Refuel" displayed on multi-information display Pulse generation (See waveform 2)
"Close Fuel Lid" displayed on multi-information display Pulse generation (See waveform 3)
Power switch on (IG) 11 to 14 V
K21-36 (TX+)*7, *11 G Input/Output - -
K21-37 (TX-)*7, *11 W Input/Output - -
K21-39 (IG+) - Body ground LA-GR - Body ground Input Power switch off → Power switch on (IG) Below 1 V → 11 to 14 V
K21-40 (B) - Body ground LA-B - Body ground Input Power switch off 11 to 14 V
K20-1 (ODO) - Body ground LA-L - Body ground Input Power switch on (IG), ODO/TRIP switch (trip switch) not pushed 4.8 to 5.2 V
K20-2 (TR) - Body ground L - Body ground Input Power switch on (IG), light control rheostat up switch (trip switch) and light control rheostat down switch (trip switch) not pushed 4.8 to 5.2 V
K20-3 (HAZ) - Body ground LA-R - Body ground Input Hazard warning signal switch off → Hazard warning signal switch pushed 11 to 14 V → Below 1 V
K20-5 (SW3) - Body ground LA-B - Body ground - Always Below 1 Ω
K20-7 (LR) - Body ground LA-G - Body ground Output Power switch on (IG), RH turn indicator light off → RH turn indicator light blinking Below 1 V → 11 to 14 V ←→ Below 1 V
K20-8 (B) - Body ground LA-B - Body ground Input Power switch off 11 to 14 V
K20-10 (TRNL) - Body ground BE - Body ground Output Power switch on (IG), LH turn indicator light off → LH turn indicator light blinking Below 1 V → 11 to 14 V ←→ Below 1 V
K20-11 (LL) - Body ground LA-LG - Body ground Output Power switch on (IG), LH turn indicator light off → LH turn indicator light blinking Below 1 V → 11 to 14 V ←→ Below 1 V
K20-13 (TRNR) - Body ground BE - Body ground Output Power switch on (IG), RH turn indicator light off → RH turn indicator light blinking Below 1 V → 11 to 14 V ←→ Below 1 V

*1: w/ Canister Pump Module

*2: w/ Rear Seat Belt Warning

*3: w/ Rear Sunshade System

*4: w/ Tire Pressure Warning System

*5: w/o Occupant Classification System

*6: w/ Washer Fluid Level Warning System

*7: w/ No. 1 Stereo Jack Adapter Assembly

*8: for LHD

*9: for RHD

*10: w/ Front Passenger Seat Belt Warning System

*11: for Multi-information Display (7 Inch Display)


E267248N02
2.969,1.198 3.323,1.396 0.354,0.198 10 false GND 1.156,1.625 1.365,1.833 0.208,0.208 10 false A

Waveform 1:

Item Condition
Tester connection
·

K21-5 (SI) - Body ground

·

K21-6 (+S) - Body ground


Tool setting 5 V/DIV., 20 ms./DIV.
Condition Power switch on (IG), wheel being rotated

HINT:

When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.


A375178E03
2.76,0.927 3.333,1.125 0.573,0.198 10 false GND

Waveform 2:

Item Condition
Tester Connection K21-34 (LST1) - Body ground
Tool setting 5 V/DIV., 20 ms./DIV.
Condition "Ready to Refuel" displayed on multi-information display

A375177E03
2.771,0.938 3.323,1.146 0.552,0.208 10 false GND

Waveform 3:

Item Condition
Tester Connection K21-34 (LST1) - Body ground
Tool setting 5 V/DIV., 20 ms./DIV.
Condition "Close Fuel Lid" displayed on multi-information display

HINT:

This waveform is output when the fuel lid opener switch is operated if the fuel lid is open and any of the following conditions are met:

·

The vehicle has been driven for 1 km (0.6 mile) or more at a speed of 50 km/h (31 mph) or more.

·

30 minutes or more have elapsed since the fuel lid opener switch was operated.



E400349N01
2.958,0.917 3.396,1.219 0.438,0.302 10 false GND 0.615,0.646 0.771,0.844 0.156,0.198 10 false A 1.823,0.646 1.979,0.844 0.156,0.198 10 false A

Waveform 4:

Item Condition
Tester Connection K21-14 (FR) - K21-33 (FE)
Tool setting 2.5 V/DIV., 20 ms./DIV.
Condition Power switch on (IG), fuel level full → Fuel level low (fuel level warning light on)

HINT:
·

(A) varies depending on the fuel level.

·

Power switch on (IG), fuel level full → Fuel level low (fuel level warning light on) (4.1 to 4.6 V → 0.3 to 1.2 V)



E400350N01
2.958,0.896 3.417,1.094 0.458,0.198 10 false GND

Waveform 5:

Item Condition
Tester Connection K21-15 (FV) - Body ground
Tool setting 2.5 V/DIV., 20 ms./DIV.
Condition Power switch on (IG)

HINT:

Power switch on (IG) (4.5 to 5.5 V)