The combination meter assembly and radio and display receiver assembly communicate via local bus communication. This allows audio and visual system information to be displayed on the multi-information display.
This DTC is stored when a communication error occurs between the radio and display receiver assembly and combination meter assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| B132187 | Lost Communication with EMV Missing Message | Diagnosis Condition:
·
The power switch is on (IG) ·
IG power source voltage is 9.5 V or more Malfunction Status: No communication with radio and display receiver assembly Malfunction Time: 3.0 seconds or more |
·
Harness or connector ·
Radio and display receiver assembly ·
Meter mirror sub-assembly* ·
Combination meter assembly |
DTC stored | w/ No. 1 Stereo Jack Adapter Assembly (for 7 Inch Multi-information Display) |
*: w/ Headup Display System
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/o Headup Display System | A |
| w/ Headup Display System | B |
A
B
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/o Navigation System | A |
| w/ Navigation System | B |
A
B
Check if audio and visual system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Check if navigation system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Replace the combination meter assembly with a new one.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Turn the power switch on (IG) and wait 3 seconds.
A minimum of 3 seconds is required to send/receive the registration information between the combination meter assembly and radio and display receiver assembly.
Operate the steering pad switch assembly and check that the audio tab illuminates.
Check if meter / gauge system DTCs are output.
| Result | Proceed to |
|---|---|
| The audio tab illuminates and DTC B132187 is not output | A |
| The audio tab does not illuminate and DTC B132187 is output | B |
A
B
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/o Navigation System | A |
| w/ Navigation System | B |
A
B
Check if audio and visual system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Check if navigation system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Check if headup display system DTCs are output.
| Result | Proceed to |
|---|---|
| DTC B132187 is not output | A |
| DTC B132187 is output | B |
A
B