The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Taillight Relay | Taillight relay | OFF or ON | - |
| Tester Display |
|---|
| Taillight Relay |
Taillights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3F instrument panel junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3F-1 - Body ground | Power switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Connect a positive (+) lead from the auxiliary battery to terminal 3F-1.
Connect a negative (-) lead from the auxiliary battery to terminal MB-14 (TRLY).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3C-32 - Auxiliary battery negative (-) terminal | Always | 11 to 14 V |
| 3D-30 - Auxiliary battery negative (-) terminal | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG