The main body ECU (multiplex network body ECU) controls the daytime running lights.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Check the operation of the clearance lights.
The clearance lights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Daytime Running Light | Daytime running lights | OFF or ON | - |
| Tester Display |
|---|
| Daytime Running Light |
Daytime running lights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the DRL relay.
Click hereVehicle Exterior>LIGHTING (EXT)>RELAY>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (DRL relay) - Body ground | Power switch off | 11 to 14 V |
| 3 (DRL relay) - Body ground | Power switch off | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A74 headlight assembly LH connector.
Disconnect the A73 headlight assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (DRL relay) - A74-6 (B) | Always | Below 1 Ω |
| 5 (DRL relay) - A73-6 (B) | Always | Below 1 Ω |
| 5 (DRL relay) or A74-6 (B) - Body ground | Always | 10 kΩ or higher |
| 5 (DRL relay) or A73-6 (B) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3C instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (DRL relay) - 3C-28 | Always | Below 1 Ω |
| 2 (DRL relay) or 3C-28 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3C-28 - MB-25 (DRL) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG