Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU › 2018.04–2021.02
RM33C0E _56 Audio / Visual / Telematics _065451 NAVIGATION / MULTI INFO DISPLAY _0333831 NAVIGATION ECU A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.


·

After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.



Hide 2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)

Hide 55435B 3.REMOVE NO. 1 METER HOOD CLUSTER

Hide 55012A 4.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55480D 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55670 6.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 7.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET

Hide 86453 8.REMOVE MULTI-MEDIA MODULE WIRE

Hide 86842 9.REMOVE NO. 1 NAVIGATION WIRE

a.

for LHD:

i.
E372249

Disconnect the 3 connectors to remove the No. 1 navigation wire.



b.

for RHD:

i.
E372251

Disconnect the 3 connectors to remove the No. 1 navigation wire.



Hide 86211J 10.REMOVE NO. 1 RADIO RECEIVER BRACKET

Hide 86212C 11.REMOVE NO. 2 RADIO RECEIVER BRACKET

Hide 86140A 12.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY

Hide 86841 13.REMOVE NAVIGATION ECU