The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
53851M
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (w/ Cover)
53852K
3.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (w/ Cover)
51441
4.REMOVE NO. 1 ENGINE UNDER COVER (w/ Cover)
51442
5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (w/ Cover)
58166A
6.REMOVE FRONT FLOOR COVER LH (w/ Cover)
53737B
7.REMOVE FRONT FENDER APRON SEAL LH
48069
8.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.