Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat) › 2018.04–2019.02
RM33C0E _58 Vehicle Interior _065462 SEAT _0333610 LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat) A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Position control ECU assembly (driver seat)

·

Front seatback frame sub-assembly (driver seat)

·

Front seat adjuster assembly (driver seat)


Initialize position control ECU Front power seat control system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.

·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 71868N 3.REMOVE FRONT SEAT FRONT CUSHION SHIELD

Hide 71812D 4.REMOVE FRONT SEAT CUSHION SHIELD

Hide 71862 5.REMOVE FRONT SEAT INNER CUSHION SHIELD

Hide 6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (w/o Front Seat Side Airbag)

Hide 7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (w/ Front Seat Side Airbag)

Hide 71931 8.REMOVE FRONT SEAT HEADREST SUPPORT

Hide 9.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 85867 10.REMOVE SEATBACK CLIMATE CONTROL BLOWER (w/ Climate Control Seat System)

Hide 72760D 11.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY

a.

w/ Climate Control Seat System:

i.
B490196C01
0.854,1.083 0.646,0.667 0.646,0.667 0.479,0.667 true 2.625,1.083 2.833,0.667 2.833,0.667 3,0.667 true 3.031,0.583 3.344,0.74 0.313,0.156 10 false *a 0.281,0.583 0.49,0.813 0.208,0.229 10 true *b
*a Clamp (A)
*b Clamp (B)


Disengage the clamp (A).



b.

Disconnect the lumbar support adjuster assembly connector.


c.

Disengage the clamp (B).


d.
B439755

Disengage the 2 claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.


e.
B439766C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the lumbar support adjuster assembly from the front seatback frame sub-assembly as shown in the illustration.


f.

Remove the seatback felt from the lumbar support adjuster assembly.


Hide 71587 12.REMOVE FRONT SEATBACK EDGE PROTECTOR