Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) › 2018.04–2019.02
RM33C0E _58 Vehicle Interior _065462 SEAT _0345651 LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly RH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



PROCEDURE

Hide 71073S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72494 3.REMOVE VERTICAL ADJUSTING HANDLE RH

Hide 72551B 4.REMOVE RECLINING HINGE COVER RH

Hide 72525A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Hide 71848A 6.REMOVE SEAT ADJUSTER COVER CAP RH

Hide 71811D 7.REMOVE FRONT SEAT CUSHION SHIELD RH

Hide 71861 8.REMOVE FRONT SEAT INNER CUSHION SHIELD RH

Hide 9.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71931 10.REMOVE FRONT SEAT HEADREST SUPPORT

Hide 11.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 72750D 12.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY RH

a.
B491286

Disconnect the connector.


b.

Disengage the clamp.


c.
B491287

Disengage the 2 claws to remove the 2 front seatback edge protectors from the front seatback frame sub-assembly.


d.
B491288C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the lumbar support adjuster assembly RH from the front seatback frame sub-assembly as shown in the illustration.


e.

Remove the seatback felt from the lumbar support adjuster assembly RH.


Hide 71587 13.REMOVE FRONT SEATBACK EDGE PROTECTOR