Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › from 2018.08
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330496 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81536A 1.REMOVE REAR COMBINATION LIGHT LED (for Bulb Type Back-up Light)

a.
E387726

Disconnect the connector.


b.

Remove the screw.


c.
E387728C01
0,0 0,0 false
V113147

Remove in this Direction


Turn the rear combination light LED as shown in the illustration to remove it.


Hide 81552C 2.REMOVE REAR COMBINATION LIGHT GASKET (for Bulb Type Back-up Light)

a.
E365013

Remove the rear combination light gasket.

NOTICE:

After the rear combination light gasket is removed, be sure to replace it with a new one. Failure to do so may cause water ingress.



Hide 81550L 3.REMOVE REAR TURN SIGNAL LIGHT BULB (for Bulb Type Back-up Light)

a.
E387730C01
0,0 0,0 false
V113147

Disconnect in this Direction


Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.


b.

Remove the rear turn signal light bulb from the rear combination light socket and wire.


Hide 81565E 4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE (for Bulb Type Back-up Light)

a.

for Type A:

i.
E386214

Disengage the 2 clamps.


ii.

Disconnect the connector to remove the rear combination light socket and wire.



b.

for Type B:

i.
E378072

Disengage the clamp to remove the rear combination light socket and wire.



Hide 81565D 5.REMOVE REAR COMBINATION LIGHT CORD (for LED Type Back-up Light)

a.
E371342

Disengage the 2 clamps.


b.

Disconnect the connector to remove the rear combination light cord.


Hide 81561D 6.REMOVE REAR COMBINATION LIGHT LENS AND BODY (for Bulb Type Back-up Light)