Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.
Disconnect the K4 radio and display receiver assembly connector.
Disconnect the K9 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| K4-3 (RL+) - K9-15 (II1+) | Always | Below 1 Ω |
| K4-8 (RL-) - K9-14 (II1-) | Always | Below 1 Ω |
| K9-18 (SLD1) - Body ground | Always | 10 kΩ or higher |
| K4-3 (RL+) or K9-15 (II1+) - Body ground | Always | 10 kΩ or higher |
| K4-8 (RL-) or K9-14 (II1-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG