84431
1.INSPECT VEHICLE APPROACHING SPEAKER SWITCH
| *a | Component without harness connected
(Vehicle Approaching Speaker Switch) |
| *b | Indicator |
Vehicle approaching speaker switch Inspection
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (IG) - 2 (ECU) | Switch on | Below 1 Ω |
| Switch off | 10 kΩ or higher |
If the result is not as specified, replace the vehicle approaching speaker switch.
Illumination Inspection
Apply auxiliary battery voltage to the vehicle approaching speaker switch and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the vehicle approaching speaker switch.
Indicator Inspection
Apply auxiliary battery voltage to the vehicle approaching speaker switch and check that the indicator illuminates.
| Condition | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 5 (IG)
Auxiliary battery negative (-) → Terminal 4 (IND) |
Illuminates |
If the result is not as specified, replace the vehicle approaching speaker switch.