Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER SYSTEM › from 2018.08
RM33C0E _59 Vehicle Exterior _065469 DOOR / HATCH _0333676 FUEL LID OPENER SYSTEM U

DOOR / HATCH  FUEL LID OPENER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List.*

*: w/ Canister Pump Module



e.

Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Fuel Filler Opener Fuel lid lock with motor assembly status OFF or ON OFF: Fuel lid lock with motor assembly not operating
ON: Fuel lid lock with motor assembly operating
-
Fuel Lid SW Fuel lid open request signal Close or Open Close: Fuel lid opener switch not pushed for 0.8 seconds.
Open: Fuel lid opener switch pushed for 0.8 seconds.
·

Customize settings set to default

·

The Data List item "Fuel Lid SW" indicates when fuel lid request signal sent from the main body ECU (multiplex network body ECU) is received by the ECM. The fuel lid takes a few seconds to open after the fuel lid request signal is received.


Fuel Lid Sensor SW Fuel lid courtesy switch status Close or Open Close: Fuel lid closed
Open: Fuel lid open
-

f.

Enter the following menus: Body Electrical / Main Body / Data List.


g.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Fuel Lid Opener Switch Fuel lid opener switch status OFF or ON OFF: Fuel lid opener switch not pushed
ON: Fuel lid opener switch pushed
-
Trunk / Fuel Opener SW Operation Setting Operation method of opening the fuel lid Short or Long Customize setting displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Active Test.*

*: w/ Canister Pump Module



e.

Perform the Active Test according to the display on the GTS.

Powertrain > Engine > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Activate the Fuel Filler Opener Fuel lid lock with motor assembly OFF/ON -

f.

Enter the following menus: Body Electrical / Main Body / Active Test.


g.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Fuel Lid Opener Fuel lid lock with motor assembly OFF/ON -