Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › 2019.02–2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0383394 ROAD SIGN ASSIST SYSTEM C

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  C1AA0  Front Camera Module Circuit  


DESCRIPTION

When an internal malfunction is detected in the forward recognition camera, DTC C1AA0 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA0 Front Camera Module Circuit After the power switch is turned on (IG) for 3 seconds or more, the forward recognition camera detects an internal malfunction. Forward recognition camera

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



PROCEDURE

1.CHECK FOR DTCs
a.

Clear the DTCs.

Body Electrical > Road Sign Assist > Clear DTCs
50002 387

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the power switch on (IG) and wait 3 seconds or more.




c.

Check for DTCs.

Body Electrical > Road Sign Assist > Trouble Codes
50001 387

Result:
Result Proceed to
DTC C1AA0 is not output A
DTC C1AA0 is output B



A

B

REPLACE FORWARD RECOGNITION CAMERA