Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › 2019.02–2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0383394 ROAD SIGN ASSIST SYSTEM C

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  U0123  Lost Communication with Yaw Rate Sensor Module  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

When a malfunction is detected between various ECUs and sensors, these DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0123 Lost Communication with Yaw Rate Sensor Module After the power switch is turned on (IG) for 3 seconds or more, when the vehicle is being driven at a speed of 1 km/h or 1 mph or more, a communication error between the yaw rate sensor (airbag sensor assembly) and forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Yaw rate sensor (Airbag sensor assembly)

·

Forward recognition camera


U0129 Lost Communication with Brake System Control Module After the power switch is turned on (IG) for 3 seconds or more, a communication error between the skid control ECU (brake booster with master cylinder assembly) and forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Skid control ECU (Brake booster with master cylinder assembly)

·

Forward recognition camera



PROCEDURE

1.CHECK FOR DTCs
a.

Clear the DTCs.

Body Electrical > Road Sign Assist > Clear DTCs
50002 387

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the power switch on (IG) and wait 3 seconds or more.

2.

Drive the vehicle at a speed of 1 km/h or 1 mph or more for 5 seconds or more.




c.

Check for DTCs.

Body Electrical > Road Sign Assist > Trouble Codes
50001 387
OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

NG