Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065451 NAVIGATION / MULTI INFO DISPLAY _0333738 NAVIGATION SYSTEM L

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:
·

After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the terminal is reconnected.

System Name See Procedure
Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Support Brake System
Parking Assist Monitor System
Pre-collision System




PRECAUTION FOR NAVIGATION SYSTEM


NOTICE:
·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.


·

When performing the following work, the navigation system may restart when turning the power switch on (ACC) (due to radio and display receiver assembly and navigation ECU certification).

-

Repair or replace the negative (-) auxiliary battery terminal due to it being disconnected or depleted.

-

The radio and display receiver assembly or navigation ECU replacement or removal and installation.


·

When replacing the telematics transceiver, be sure to replace it with a new one (w/ Telematics Transceiver).

·

After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.

·

After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.