CUSTOMIZE CLOCK SYSTEM
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
The following items can be customized.
Customizing with the multi-display
Turn the power switch on (IG).
Enter the following menus: MENU / Setup / Clock.
Select the setting by referring to the table below.
| Display | Default | Description | Setting | Relevant ECU |
|---|---|---|---|---|
| Time zone | *1 | Setting for clock time zone | *2 | Radio and display receiver assembly |
| Daylight saving time | *1 | Setting for clock daylight saving time | On or Off | Radio and display receiver assembly |
| Auto adjust by GPS | On | Setting for clock auto adjust by GPS | On or Off | Radio and display receiver assembly |
| 24-hour time format | *1 | Setting for clock 24-hour time format | On or Off | Radio and display receiver assembly |
| Hours | - | Manual adjustment of clock hour | -, +, AM or PM | Radio and display receiver assembly |
| Minutes | - | Manual adjustment of clock minute | -, + or :00 | Radio and display receiver assembly |
*1: Differs depending on vehicle
*2: Content differs depending on destination market
Customizing with the multi-information display*
Turn the power switch on (IG).
Select the settings tab on the screen of the multi-information display.
Choose the following items and perform customization of the clock (combination meter assembly).
| Display | Description | ECU |
|---|---|---|
| Clock Setting | Set minutes to 00 | Combination meter assembly |
| 12H/24H setting and clock adjustment |
*: w/ Clock (Combination Meter Assembly)