Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _078700 TELEMATICS _0387130 TELEMATICS SYSTEM(for eCall) M

TELEMATICS  TELEMATICS SYSTEM(for eCall)  REGISTRATION  


PROCEDURE

Hide 1. REGISTER VEHICLE INFORMATION

HINT:

If the telematics transceiver has been replaced, it is necessary to perform the Register Vehicle Information procedure.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization

Body Electrical > Telematics > Utility
Tester Display
VIN Synchronization
50005 233 2391

e.

According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.


f.

Enter the following menus: Body Electrical / Telematics / Utility / ID Information Display


g.

According to the display on the GTS, read the IMEI, ICCID and VIN.


Hide 2. DCM ACTIVATION

HINT:
·

Before DCM activation, make sure to perform vehicle information registration.

·

Perform the activation outside to ensure GNSS signal is available.

·

Immediately after the power switch is turned on (IG), if the manual (SOS) switch indicator (green) illuminates continuously after the manual (SOS) switch indicator (red) illuminates for 10 seconds, it is not necessary to perform the following procedure. (eCall Only Mode)



a.

Turn the power switch on (IG) and confirm that the manual (SOS) switch illuminated indicators.


b.

Immediately after the power switch is turned on (IG), if the manual (SOS) switch indicator (green) illuminates for 2 seconds and then turns off after the manual (SOS) switch indicator (red) illuminates for 10 seconds, perform the following procedure. (Shipping Mode)

i.

Wait 80 seconds, and then press and hold the manual (SOS) switch for 3 to 10 seconds and check that a beep sound is heard.


ii.

Wait 5 minutes.

NOTICE:

Do not press the manual (SOS) switch while waiting.



iii.

Turn the power switch off.


iv.

Turn the power switch on (IG) and check the illumination status of the manual (SOS) switch indicators.

If the indicators illuminate in the following pattern, activation is complete: red (10 sec.), green (2 sec.), red and green together (1sec), then only green stays illuminated.

HINT:

When performing DCM activation outside of the communication area, the same illumination pattern as eCall Only Mode is displayed. When the vehicle enters a communication area, the system automatically restarts DCM activation and switches to Live Mode.




Hide 3.RESET MOBILEPHONE BATTERY CONDITION

HINT:

If the mobilephone battery has been replaced, it is necessary to perform the Backup Battery Replacement Reset Condition procedure.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Telematics / Utility / Backup Battery Reset

Body Electrical > Telematics > Utility
Tester Display
Backup Battery Replacement Reset
50005 233 4392

e.

According to the display on the GTS, perform Backup Battery Replacement Reset to reset the mobilephone battery replacement flag.