Check from the rear of the connector while it is connected to the components.
TELEMATICS TRANSCEIVER
| *a | Connector Color: Gray (to GNSS Antenna) | *b | Connector Color: Blue (to Telephone Antenna) |
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K157-1 (+B) - K157-4 (E) | B - W-B | Power source (+B) | Power switch off | 11 to 14 V |
| K157-4 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 V |
| K157-7 (IG2) - K157-4 (E) | LG - W-B | Power source (IG) | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| K157-8 (ACC) - K157-4 (E) | B - W-B | Power source (ACC) | Power switch on (ACC) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| K157-9 (SLED) - K157-4 (E) | SB - W-B | Manual (SOS) switch illumination power supply | Power switch on (ACC) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| K157-11 (IND1) - K157-4 (E) | P - W-B | Manual (SOS) switch indicator (red) illumination signal | For 10 seconds after power switch turned on (IG) | 1 to 8.5 V |
| Power switch off | Below 1 V | |||
| K157-12 (IND2) - K157-4 (E) | LG - W-B | Manual (SOS) switch indicator (green) illumination signal | For 2 seconds after power switch turned on (IG) | 1 to 8.5 V |
| Power switch off | Below 1 V | |||
| K157-14 (MCMD) - K157-4 (E) | BE - W-B | Microphone mode signal | Microphone mode | 0.5 V or higher |
| Emergency call mode | 0.5 V or less | |||
| K157-15 (CANP) | R | CAN communication signal | - | - |
| K157-16 (CANN) | W | CAN communication signal | - | - |
| K157-20 (SP+) - K157-4 (E) | SB - W-B | Sound signal | Sound being output from built-in speaker of communication telematics box | A waveform synchronized with sound signals is output |
| K157-21 (SP-) - K157-4 (E) | GR - W-B | Sound signal | Sound being output from built-in speaker of communication telematics box | A waveform synchronized with sound signals is output |
| K157-24 (GSW) - K157-4 (E) | W - W-B | Collision detection signal | Power switch on (IG) | Pulse generation
(Refer to waveform 1) |
| K157-26 (SIG-) - K157-4 (E) | GR - W-B | Ground | Always | Below 1 Ω |
| K157-27 (SIG1) - K157-4 (E) | B - W-B | Manual (SOS) switch condition signal | Manual (SOS) switch not pressed | 2.0 to 2.3 V |
| Manual (SOS) switch pressed | Below 1 V | |||
| K157-31 (MICV) - K157-4 (E) | G - W-B | Communication telematics box power supply | Power switch off | Below 1 V |
| Power switch on (IG) | 4 to 6 V | |||
| K157-32 (SGND) - K157-4 (E) | Shielded - W-B | Shield ground | Always | Below 1 V |
| K157-33 (MCVD) - K157-4 (E) | B - W-B | Receive microphone voice signal | Voice being input to built-in microphone of communication telematics box | A waveform synchronized with microphone voice signal is input |
| K157-34 (MCI+) - K157-4 (E) | W - W-B | Receive microphone voice signal | Voice being input to built-in microphone of communication telematics box | A waveform synchronized with microphone voice signal is input |
| K157-35 (MCI-) - K157-4 (E) | R - W-B | Ground | Always | Below 1 V |
| *a | Waveform 1 |
Oscilloscope waveform:
Waveform 1
| Item | Condition |
|---|---|
| Tester connection | K157-24 (GSW) - K157-4 (E) |
| Tool setting | 5.0 V/DIV., 20 ms/DIV. |
| Vehicle condition | Power switch on (IG) |