This DTC is stored when the Vehicle Identification Number (VIN) is not stored in the telematics transceiver or when the VIN stored in the telematics transceiver and the VIN stored in the ECM do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F0 | VIN Not Programmed or Mismatch - DCM | When either of the following conditions is met for 7.5 seconds or more:
·
The VIN is not stored in the telematics transceiver ·
The VIN stored in the telematics transceiver and the VIN stored in the ECM do not match |
·
SFI system ·
CAN communication system |
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and wait for 20 seconds or more.
Turn the GTS on.
Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization
| Tester Display |
|---|
| VIN Synchronization |
According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and wait for 10 seconds or more.
Turn the GTS on.
Clear the DTCs.
Check for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
CAN communication system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
w/ Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>HOW TO PROCEED WITH TROUBLESHOOTING
w/o Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING