Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387691 PARKING SUPPORT BRAKE SYSTEM C

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  C1647  G Sensor Failure  


DESCRIPTION

The clearance warning sonar ECU assembly communicates with the yaw rate and acceleration sensor via CAN communication, and if it is determined that the yaw rate and acceleration sensor is malfunctioning, DTC C1647 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1647 G Sensor Failure Yaw rate and acceleration sensor malfunction Electronically controlled brake system

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION



PROCEDURE

1.CHECK DTC OUTPUT
a.

Using the GTS, check for DTCs according to the prompts on the screen.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs according to the screen on the GTS.

Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
HINT:
·

DTC C1647 is stored when a malfunction signal sent from the electronically controlled brake system is detected.

·

If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1647 will not be output again.

·

If DTC C1647 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




Result:
Result Proceed to
DTC C1647 is output A
DTC C1647 is not output B



A

B