When a hybrid control system malfunction signal sent by the hybrid vehicle control ECU is detected by the clearance warning ECU assembly, DTC C1A40 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A40 | ENG / EHV Device | When the power switch is on (IG), a hybrid control system malfunction signal is detected for 1 second or more. | ·
Hybrid control system ·
Clearance warning ECU assembly |
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION
Using the GTS, check for DTCs according to the prompts on the screen.
After turning the power switch from off to on (IG), wait 4 seconds or more before checking for DTCs.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
DTC C1A40 is stored when a malfunction signal sent from the hybrid control system is detected.
If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1A40 will not be output again.
If DTC C1A40 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| DTC C1A40 is output | A |
| DTC C1A40 is not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING