Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387691 PARKING SUPPORT BRAKE SYSTEM C

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  C1AF3  Fr Sensor Initialization Incomplete  


DESCRIPTION

When it is judged that the front sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF3.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF3 Fr Sensor Initialization Incomplete Front sensor not initialized
·

Initialize front sensor

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

If DTC C1AF3 is output after performing repairs, turn the power switch on (IG) and turn the parking support brake system on to clear the DTC.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>DTC CHECK / CLEAR

·

After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION



PROCEDURE

1.INITIALIZE FRONT CENTER ULTRASONIC SENSOR AND FRONT CORNER ULTRASONIC SENSOR
a.

Initialize the front center ultrasonic sensor and front corner ultrasonic sensor.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

HINT:

After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AF3 is output A
DTC C1AF3 is not output B


HINT:

If DTC C1AF3 is still output after initializing the front center ultrasonic sensor and front corner ultrasonic sensor 3 times, replace the clearance warning ECU assembly.



A

B

END (FRONT SENSORS WERE NOT INITIALIZED)