Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387691 PARKING SUPPORT BRAKE SYSTEM C

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  C1AF4  Rr Sensor Initialization Incomplete  


DESCRIPTION

When it is judged that the rear sensors have not been initialized, the clearance warning ECU assembly stores DTC C1AF4.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AF4 Rr Sensor Initialization Incomplete Rear sensor not initialized
·

Initialize rear sensor

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

If DTC C1AF4 is output after performing repairs, turn the power switch on (IG) and turn the parking support brake system on to clear the DTC.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>DTC CHECK / CLEAR

·

After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION



PROCEDURE

1.INITIALIZE REAR CENTER ULTRASONIC SENSOR AND REAR CORNER ULTRASONIC SENSOR
a.

Initialize the rear center ultrasonic sensor and rear corner ultrasonic sensor.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Using the GTS, check for DTCs according to the prompts on the screen.

HINT:

After turning the power switch from off to on (IG), wait 10 seconds or more before checking for DTCs.


Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AF4 is output A
DTC C1AF4 is not output B


HINT:

if DTC C1AF4 is still output after initializing the rear center ultrasonic sensor and rear corner ultrasonic sensor 3 times, replace the clearance warning ECU assembly.



A

B

END (REAR SENSORS WERE NOT INITIALIZED)