Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Parking Support Brake System) › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387692 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System) W

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System)  CUSTOMIZE PARAMETERS  


CUSTOMIZE TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

Customizing with the GTS.

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the TOYOTA parking assist-sensor system on.


iv.

Turn the GTS on.


v.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility / Customize Setting.


vi.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
Fr Corner Sensor Onset Range Sets the detection operation range for the front corner sensors. Long 0:Short,1:Long Clearance warning ECU assembly
Rr Corner Sensor Onset Range Sets the detection operation range for the front corner sensors. Long 0:Short,1:Long Clearance warning ECU assembly
Fr Sensor Onset Range Sets the detection operation range for the front center sensors. Wide 0:Narrow,1:Wide Clearance warning ECU assembly
Rr Sensor Onset Range Sets the detection operation range for the rear center sensors. Wide 0:Narrow,1:Wide Clearance warning ECU assembly
Keep Sense Buzzer Sets whether the buzzer stops sounding when the distance between the vehicle and a detected object does not change for 3 seconds. Avail 0:Not Avail,1:Avail Clearance warning ECU assembly
Fr & Rr Buzzer Volume Changes the buzzer volume setting. M2 001:L,010:M1,011:M2,100:M3,101:H Clearance warning ECU assembly
Object Not Moving 3s Buzz Vol Sets the volume at which the buzzer sounds when the distance between the vehicle and a detected object does not change for 3 seconds. Keep 00:Keep Vol,01:L,10:M1,11:M2 Clearance warning ECU assembly
Leave Buzzer Volume Sets the volume of the buzzer with respect to the distance between the vehicle and a detected object. L 00:Keep Vol,01:L,10:M1,11:M2 Clearance warning ECU assembly
Temporary Mute Reset Speed Adjust Sets the vehicle speed at which the temporary mute function resets. 20 km/h 00:System Link,01:15km/h,10:20km/h,11:30km/h Clearance warning ECU assembly
Temporary Mute Function Sets the availability of the temporary mute function. ON 0:OFF,1:ON Clearance warning ECU assembly
50006 7
Sensor
Tester Display Description Default Setting ECU
Sensor Condition N Makes the front sensors available when the shift lever is in N. Avail 0:Not Avail,1:Avail Clearance warning ECU assembly
50006 13
Display
Tester Display Description Default Setting ECU
Approach Display OFF Sets whether the display turns off after an obstacle is no longer detected. Avail 0:Not Avail,1:Avail Clearance warning ECU assembly
Display Mode The display mode setting (when the TOYOTA parking assist-sensor system is normal). All 01:All,11:Undisp Clearance warning ECU assembly
50006 14