Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Parking Support Brake System) › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387692 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System) D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System)  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST INTUITVE PARKING ASSIST SYSTEM


a.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Registration of bumper type (Click here)
Steering angle neutral point*
Bumper type registration
Ultrasonic sensor detection angle registration
Ultrasonic sensor
·

Removal and installation

·

Replacement


Ultrasonic sensor detection angle measurement
Ultrasonic sensor detection angle registration
An ultrasonic sensor becomes misaligned Ultrasonic sensor detection angle measurement
Ultrasonic sensor detection angle registration
An ultrasonic sensor is subjected to impact Ultrasonic sensor detection angle measurement
Ultrasonic sensor detection angle registration

*: The steering sensor zero point can also be calibrated by driving the vehicle.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>INITIALIZATION