The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 5 antenna cord sub-assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE ROOF HEADLINING ASSEMBLY
86101R
2.REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY
Disconnect the 2 connectors.
Disengage the 9 clamps to remove the No. 5 antenna cord sub-assembly.