Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2019.02–2021.02
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0328281 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking Assist-sensor System

·

Parking Support Brake System


(Click here)

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

a.
B470343

Remove the 5 clips.


b.
B470344C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Disengage the guide and remove the cool air intake duct seal as shown in the illustration.


Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B470346C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly as shown in the illustration.


b.
B610750C02
1.073,1.74 1,1.583 true 1,1.74 1.198,1.938 0.198,0.198 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



c.
B470347

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



d.
B470353

Remove the 8 screws.


e.
B470354C01
0,0 0,0 false
V113146

Place Hand Here
V113147

Remove in this Direction


Disengage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B479929C03
1.01,0.604 1.271,0.813 0.26,0.208 12 true *A
*A w/ Pre-collision System


w/ Pre-collision System:

i.

Disconnect the connector.



g.

Disconnect the connector.


h.
B470356

Remove the 2 clips.


i.

Remove the 4 bolts.


j.
B488711C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws and 2 guides to remove the front bumper assembly as shown in the illustration.


k.

w/ Fog Light:

i.

Disconnect the connector.



l.
B490252

w/ Headlight Cleaner System:

i.

Disconnect the headlight cleaner hose and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.