Home › Engine / Hybrid System › A25A-FXS (FUEL) › FUEL TANK (w/o Canister Pump Module) › 2019.02–2021.02
RM33C0E _51 Engine / Hybrid System _065421 A25A-FXS FUEL _0319777 FUEL TANK(w/o Canister Pump Module) A

A25A-FXS FUEL  FUEL TANK(w/o Canister Pump Module)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Parking Support Brake System*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Gas leak from exhaust system is repaired Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

·
A344817

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 2.DRAIN FUEL

Hide 17420 3.REMOVE CENTER EXHAUST PIPE ASSEMBLY

Hide 58399D 4.REMOVE NO. 2 FLOOR UNDER COVER (w/ Cover)

Hide 77641A 5.REMOVE NO. 1 FUEL TANK PROTECTOR

a.

for Type A:

i.
A456258

Remove the 2 clips.


ii.

Disengage the clamp to remove the No. 1 fuel tank protector from the fuel tank assembly.



b.

for Type B:

i.
A405279

Remove the 3 clips and No. 1 fuel tank protector from the fuel tank assembly.



Hide 77209F 6.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A428884C01
0.073,0.031 0.448,0.271 0.375,0.24 12 false *A 0.073,2.375 0.448,2.615 0.375,0.24 12 false *B
*A for Type A
*B for Type B


Disconnect the fuel tank main tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>A25A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 77754B 7.DISCONNECT CHARCOAL CANISTER OUTLET HOSE

a.
A405264

Disconnect the charcoal canister outlet hose from the fuel tank filler pipe assembly.


Hide 8.DISCONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY

a.

for Type A:

i.
A405265

Loosen the clamp, then disconnect the fuel tank breather tube sub-assembly from the fuel tank filler pipe assembly.



b.

for Type B:

i.
A443053

Disconnect the fuel tank breather tube sub-assembly from the fuel tank filler pipe assembly.

Click hereEngine / Hybrid System>A25A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION



Hide 77213E 9.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.

for Type A:

i.
A405267

Loosen the clamp, then disconnect the fuel tank to filler pipe hose from the fuel tank assembly.



b.

for Type B:

i.
A443054

Disconnect the fuel tank to filler pipe hose from the fuel tank assembly.

Click hereEngine / Hybrid System>A25A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION



Hide 77100 10.REMOVE FUEL TANK ASSEMBLY

CAUTION:

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.


a.
A405270

Support the fuel tank assembly using an engine lifter.

HINT:

Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.



b.
A405271

Remove the 4 bolts, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH.


c.

Lower the engine lifter to remove the fuel tank assembly.

NOTICE:
·

Be careful not to drop the fuel tank assembly.

·

When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.




Hide 77209F 11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A405274

Disengage the 2 clamps to remove the fuel tank main tube sub-assembly from the fuel tank assembly.


Hide 77754B 12.REMOVE CHARCOAL CANISTER OUTLET HOSE

a.
A405276

Disengage the clamp to remove the charcoal canister outlet hose from the fuel tank assembly.


Hide 77651A 13.REMOVE NO. 1 FUEL TANK CUSHION

a.
A405277

Remove the 2 No. 1 fuel tank cushions from the fuel tank assembly.


Hide 77289B 14.REMOVE NO. 3 FUEL TUBE CLAMP (for Type A)

a.
A456259

Disengage the claw to remove the No. 3 fuel tube clamp from the fuel tank assembly.