The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
63218G
1.REMOVE SLIDING ROOF SIDE GARNISH LH
Disengage the 4 claws to remove the sliding roof side garnish LH.
63217G
2.REMOVE SLIDING ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
63201G
3.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
Move the sliding roof glass sub-assembly to the fully closed position.
Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.
To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly) to the fully closed position before removing it.
63251H
4.REMOVE SLIDING ROOF WEATHERSTRIP
Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.
62180A
5.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
62170A
6.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure as for the LH side.
7.DISCONNECT SLIDING ROOF DRAIN HOSE
Use the same procedure for all of the sliding roof drain hoses.
for Clamp Type:
Disengage the claw and disconnect the sliding roof drain hose.
for Clip Type:
Expand the clip and disconnect the sliding roof drain hose.
8.REMOVE SLIDING ROOF HOUSING ASSEMBLY
Remove the 8 bolts, 6 nuts and sliding roof housing assembly.