Home › Engine / Hybrid System › A25A-FXS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (w/ Canister Pump Module) › 2019.02–2021.02
RM33C0E _51 Engine / Hybrid System _065421 A25A-FXS FUEL _0319778 FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module) A

A25A-FXS FUEL  FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration. Lane departure alert system (w/ Steering Control) (Click here)
Parking Support Brake System*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 83320 2.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.

for Type A:

i.
A405286

Disconnect the fuel sender gauge assembly connector.


ii.

Disengage the 2 clamps to disconnect the wire harness from the fuel suction tube with pump and gauge assembly.

NOTICE:
·

Do not damage the wire harness.

·

When disengaging each wire harness from the clamp, disengage one wire at a time.




iii.
A405287

Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.




b.

for Type B:

i.
A456300

Disconnect the fuel sender gauge assembly connector.


ii.

Disengage the 2 clamps to disconnect the wire harness from the fuel suction tube with pump and gauge assembly.

NOTICE:
·

Do not damage the wire harness.

·

When disengaging each wire harness from the clamp, disengage one wire at a time.




iii.
A456301

Disengage the 2 claws to remove the fuel gauge bracket with fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



iv.
A456302

Disengage the 2 claws to remove the fuel sender gauge assembly from the fuel gauge bracket.