The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
Disconnect each connector.
Disengage each clamp.
Remove the nut and front seat inner belt assembly.
|
Remove in this Direction |
Remove the front seat belt anchor plate as shown in the illustration.
73230
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
w/ Wire Harness:
Disconnect each connector.
Disengage each clamp.
Remove the nut and front seat inner belt assembly.
|
Remove in this Direction |
Remove the front seat belt anchor plate as shown in the illustration.