The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE HEADLIGHT ASSEMBLY
for LED Type Turn Signal Light:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)>REMOVAL
for Bulb Type Turn Signal Light:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light)>REMOVAL
81056A
2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
Remove the 3 screws.
Separate the connector cover from the headlight ECU sub-assembly.
Disconnect the connector to remove the headlight ECU sub-assembly.
81134
3.REMOVE HEADLIGHT GASKET
Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
Remove the headlight gasket.