Home › Vehicle Interior › SEAT › LUMBAR SWITCH(for Manual Seat) › 2019.02–2021.02
RM33C0E _58 Vehicle Interior _065462 SEAT _0345650 LUMBAR SWITCH(for Manual Seat) A

SEAT  LUMBAR SWITCH(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lumbar power seat switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Parking support brake system*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



PROCEDURE

Hide 71073S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72494 3.REMOVE VERTICAL ADJUSTING HANDLE RH

Hide 72551B 4.REMOVE RECLINING HINGE COVER RH

Hide 72525A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Hide 71848A 6.REMOVE SEAT ADJUSTER COVER CAP RH

Hide 71811D 7.REMOVE FRONT SEAT CUSHION SHIELD RH

Hide 84922A 8.REMOVE FRONT LUMBAR POWER SEAT SWITCH

a.
B491285

Remove the 2 screws and front lumbar power seat switch from the front seat cushion shield RH.