The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
71868N
3.REMOVE FRONT SEAT FRONT CUSHION SHIELD
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD
6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (w/o Front Seat Side Airbag)
7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY (w/ Front Seat Side Airbag)
71931
8.REMOVE FRONT SEAT HEADREST SUPPORT
9.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
85867
10.REMOVE SEATBACK CLIMATE CONTROL BLOWER (w/ Climate Control Seat System)
72760D
11.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY
w/ Climate Control Seat System:
| *a | Clamp (A) |
| *b | Clamp (B) |
Disengage the clamp (A).
Disconnect the lumbar support adjuster assembly connector.
Disengage the clamp (B).
Disengage the 2 claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.
|
Remove in this Direction |
Remove the lumbar support adjuster assembly from the front seatback frame sub-assembly as shown in the illustration.
Remove the seatback felt from the lumbar support adjuster assembly.
71587
12.REMOVE FRONT SEATBACK EDGE PROTECTOR