Home › Vehicle Interior › SEAT › POWER SEAT CONTROL ECU › 2019.02–2021.02
RM33C0E _58 Vehicle Interior _065462 SEAT _0333617 POWER SEAT CONTROL ECU A

SEAT  POWER SEAT CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Parking support brake system*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Position control ECU assembly (driver seat)

·

Front seatback frame sub-assembly (driver seat)

·

Front seat adjuster assembly (driver seat)


Initialize position control ECU Front power seat control system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 89710D 2.REMOVE POSITION CONTROL ECU ASSEMBLY

a.
B490198C01
0,0 0,0 false
V100135

Screw
V100136

Connector


Disconnect the 3 connectors.


b.

Remove the 3 screws and position control ECU assembly.