Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE › from 2019.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0331707 REFRIGERANT LINE A

HEATING / AIR CONDITIONING  REFRIGERANT LINE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PIPING CLAMP (for Suction Hose Sub-assembly Side)

a.

Remove the vinyl tape from the suction pipe sub-assembly and suction hose sub-assembly.


b.
E361954C01
0.656,1.833 0.656,1.49 false 2.281,1.885 1.875,1.625 false 1.271,0.615 0.51,0.292 0.51,0.292 1.292,1.427 true 0.583,1.844 0.896,2 0.313,0.156 10 false *1 2.302,1.792 2.615,1.948 0.313,0.156 10 false *2 0.333,0.135 0.646,0.292 0.313,0.156 10 false *a
*1 Suction Hose Sub-assembly
*2 Piping Clamp
*a Groove


Install a new piping clamp to the suction hose sub-assembly.

NOTICE:
·

Securely engage the inside step of the piping clamp in the groove of the suction hose sub-assembly.

·

Do not open the piping clamp more than the diameter of the suction hose sub-assembly when installing it.

·

Do not install the piping clamp with the large diameter section facing the wrong direction.




c.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces of the suction hose sub-assembly.

Compressor Oil:

ND-OIL 11 or equivalent



d.

Install the 2 O-rings to the suction hose sub-assembly.

NOTICE:

Keep the O-rings and O-ring fitting surfaces free from dirt and foreign matter.



e.
E361955C01
0.958,0.969 1.406,0.448 true 0.323,1.75 0.323,1.156 true 2.406,1.76 2.406,1.167 true 1.427,0.323 1.74,0.479 0.313,0.156 10 false *a 0.25,1.781 0.563,1.938 0.313,0.156 10 false *b 2.323,1.781 2.635,1.938 0.313,0.156 10 false *b
*a Large Diameter Section of Piping Clamp
*b Alignment Mark


Align the alignment marks and connect the suction pipe sub-assembly and suction hose sub-assembly.

NOTICE:

Connect the parts by holding the tubes, not the piping clamp.



f.
E361956C01
1.625,1.469 2.146,1.844 true 2.167,1.74 2.479,1.896 0.313,0.156 10 false *a
*a Large Diameter Section of Piping Clamp


Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction pipe sub-assembly.

NOTICE:
·

When inserting, make sure that a click sound is heard.

·

Check that the suction hose sub-assembly is securely connected by pulling it.




Hide 2.INSTALL PIPING CLAMP (for Air Conditioning Tube and Accessory Assembly Side)

Hide 3.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT