The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake actuator assembly removal/installation are shown below.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
47070
1.REMOVE BRAKE BOOSTER PUMP ASSEMBLY
2.REMOVE FRONT WHEEL RH
48820B
3.SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereSuspension>FRONT SUSPENSION>FRONT SHOCK ABSORBER>REMOVAL
4.REMOVE BRAKE ACTUATOR WITH BRACKET
|
Release the lock lever |
|
Disconnect the connector |
Release the lock lever and disconnect the connector from the brake actuator assembly.
Be careful not to allow any brake fluid to enter the connector.
| *a | From 1st Chamber of Brake Booster with Master Cylinder Assembly |
| *b | From 2nd Chamber of Brake Booster with Master Cylinder Assembly |
| *c | To Front Wheel Cylinder Assembly RH |
| *d | To Rear Wheel Cylinder Assembly LH |
| *e | To Rear Wheel Cylinder Assembly RH |
| *f | To Front Wheel Cylinder Assembly LH |
Use tags or make a memo to identify the places to reconnect the brake lines.
Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
|
Protective Tape |
Apply protective tape to the vehicle body as shown in the illustration.
Remove the 2 bolts.
Insert the tool from the bottom of the vehicle.
Remove the nut.
Remove the brake actuator with bracket as shown in the illustration.
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Be careful not to allow any brake fluid to enter the connector.
Do not hold the brake actuator assembly by the connector.
Do not drop the brake actuator with bracket when carrying it.
Remove the brake actuator with bracket while avoiding the brake lines.
44510
5.REMOVE BRAKE ACTUATOR ASSEMBLY
Remove the 3 bolts and brake actuator assembly from the brake actuator bracket assembly.
Do not hold the brake actuator assembly by the connector.
Do not drop the brake actuator assembly when carrying it.
44546A
6.REMOVE BRAKE ACTUATOR BOLT CUSHION
| *1 | Brake Actuator Case Collar |
| *2 | Brake Actuator Bolt Cushion |
Remove the 3 brake actuator case collars from the brake actuator bolt cushions.
Remove the 3 brake actuator bolt cushions from the brake actuator bracket assembly.