Home › General › MAINTENANCE › AUXILIARY BATTERY › 2019.02–2019.10
RM33C0E _V1 General _065432 MAINTENANCE _0329956 AUXILIARY BATTERY A

MAINTENANCE  AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ steering control) (Click here)
Parking Support Brake System*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.



Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

a.
A406881

Disengage the 2 claws and remove the luggage trim service hole cover.


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A406862

Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 4.REMOVE AUXILIARY BATTERY

a.
A406864

Disengage the 2 claws and open the battery terminal connector cover in the order shown in the illustration.


b.
A406863

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A406865

Disconnect the battery hose from the auxiliary battery.


d.
A406866C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the bolt and remove the No. 3 battery clamp as shown in the illustration.


e.

Remove the auxiliary battery.