Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0334382 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Blind spot monitor sensor Blind spot monitor beam axis adjustment Blind Spot Monitor System (Click here)
w/ Parking Support Brake System

Rear bumper assembly


·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)

PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 88172 2.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
E371184

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor LH.

NOTICE:

Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.



Hide 88162 3.REMOVE BLIND SPOT MONITOR SENSOR RH

a.
E371185

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor RH.

NOTICE:

Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.