The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during shift paddle switch (transmission shift switch assembly) removal/installation are shown below.
Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the power switch on (IG).
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
45100
1.REMOVE STEERING WHEEL ASSEMBLY
84250A
2.REMOVE STEERING PAD SWITCH ASSEMBLY
84610F
3.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
Remove the 2 screws.
Disengage the 4 claws.
Disengage the 2 clamps to disconnect the 2 shift paddle switches (transmission shift switch assemblies) from the steering wheel assembly.
Disconnect the 2 shift paddle switch (transmission shift switch assembly) connectors to remove the 2 shift paddle switches (transmission shift switch assemblies) from the No. 1 switch wire.
84523
4.REMOVE NO. 1 SWITCH WIRE
Perform this procedure only when replacement of the No. 1 switch wire is necessary.
Disengage the 2 guides and remove the No. 1 switch wire from the steering wheel assembly.