Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1) › from 2019.10
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0326953 AIR FUEL RATIO SENSOR(for Sensor 1) A

A25A-FXS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor (sensor 1)

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR

CAUTION:
A344783

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A449494C01
0.052,0.042 0.365,0.292 0.313,0.25 12 false *A 0.052,2.427 0.354,2.646 0.302,0.219 12 false *B
*A w/o Differential Pressure Sensor
*B w/ Differential Pressure Sensor


Disengage the 3 wire harness clamps.


b.

Disconnect the air fuel ratio sensor connector.


c.
A406052N01
0.542,0.885 0.896,0.885 true 0.198,0.802 0.531,1.01 0.333,0.208 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold (TWC: Front Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.