Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2019.10
RM33C0E _51 Engine / Hybrid System _065422 A25A-FXS EMISSION CONTROL _0406276 DIFFERENTIAL PRESSURE SENSOR A

A25A-FXS EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 25715 1.INSTALL EMISSION CONTROL VALVE BRACKET

HINT:

Perform this procedure only when replacement of the emission control valve bracket is necessary.


a.

Temporarily install the emission control valve bracket to the fuel pump flange with the nut.


b.
A453157

While pushing the emission control valve bracket in the direction shown in the illustration, tighten the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 89481B 2.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Temporarily install the differential pressure sensor to the emission control valve bracket with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.
A453158

While pushing the differential pressure sensor in the direction shown in the illustration, tighten the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the No. 1 vacuum transmitting pipe sub-assembly to the differential pressure sensor and slide the clip to secure it.


d.

Connect the differential pressure sensor connector.


Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY